Agilent AGILENT 6060B 60 A, 300 W Single Input Electronic

The Agilent 6060B is a single-input dc electronic load. It meets all specifications when operated above 3V; however, the dc operating characteristics also extend below this minimum-input voltage for static tests. The figure below shows the operating range of a typical HP dc electronic load. Low voltage operation, down to zero volts, is possible at correspondingly-reduced current levels, depending on the minimum resistance of the load. HP electronic loads, therefore, can be used in many applications that previously required zero-volt loads. Specifications. Amperes: 0 to 60 A. Volts: 3 to 60 V. Maximum power (at 40° C): 300 W. Constant current mode Ranges: 0 to 6 A, 0 to 60 A. Constant current mode Accuracy: 0.1% ±75 mA. Constant current mode Regulation: 10 mA. Constant voltage mode Accuracy 0.1% ±50 mV. Constant voltage mode Regulation (w/remote sense): 10 mV. Constant resistance mode Ranges: 0.033 to 1.0 ohm, 1 to 1,000 ohms, 10 to 10,000 ohms. Transient generator Frequency range: 0.25 Hz to 10 kHz (3% Accuracy). Current readback accuracy: 0.05% ±65 mA. Power readback accuracy: 0.2% ±4 W. Ripple and noise (20-Hz to 10-MHz noise): 4 mA rms, 40 mA peak-to-peak (Current), 6 mV rms (Voltage).