Spectrum Analyzer 20Hz-40GHz,
options:
B4 = Low Phase Noise and OCXO;
B5 = FFT-Filter 1Hz-1kHz;
B7 = Vector Signal Analyzer;
B10 = Tracking Generator 7GHz,
B12 = Switchable Attenuator for Tracking Generator
The FSE spectrum analyzers from Rohde&Schwarz have been optimized both for general-purpose measurements and meeting the stringent requirements of testing advanced digital communication systems.
The Rohde & Schwarz FSEK30 Spectrum Analyzer comes with low phase noise and OCXO, 1Hz resolution bandwidth and an FFT filter.
The FSEK30 is outstanding for its extremely low noise floor without any impairment to the dynamic range at large signal levels. This can be seen, for example, from the 1 dB compression point of +10 dBm, which yields a dynamic range of 109 dB even at a resolution bandwidth of 1MHz, allowing GSM, DECT and EDGE power ramps to be determined.
Resolution bandwidths: 1 Hz to 10 MHz, adjustable in steps of 1/2/3/5/10
Displayed noise floor: 150 dBm (typ.) in 10-Hz bandwidth
3rd-order intercept point: +20 dBm typ.
1 dB compression point of RF input: +10 dBm
Total level measurement uncertainty: up to 1 GHz <1 dB, up to 7 GHz 1.5 dB
AM/FM audio demodulator (with built-in loudspeaker and headphones connector)
Internal RF trigger (trigger threshold approx. -20 dBm)
5 ms full-span sweep time with fully synchronized sweep (FSEA, FSEB), 150 ms with FSEM, 230 ms with FSEK
1 µs zero-span sweep time
Pretrigger and trigger delay
Gated sweep
€ 26,000 (net) $32,760 (US)