SWR Bridge 5-2000 MHz, 75Ohm, N(f),
R&S ID 802.1018.73
The SWR Bridge R&S ZRB2 is used to measure the magnitude and phase of the reflection coefficient, for example of filters, amplifiers, mixers or antennas.
The output signal a from the generator is fed via the SWR Bridge to the device under test.
Part of the signal is reflected via the SWR Bridge to the indicator, the amount depending on the reflection coefficient r of the device under test.
This part b of the signal is a measure of the complex reflection coefficient r of the device under test.
Intelligent indicators convert the measured reflection coefficient into other parameters, e.g. the impedance or admittance of the device under test.
In this case, display is possible as magnitude and phase as well as real and imaginary quantities.
Wide frequency range: 5 to 3000 MHz (This model has 2000 MHz)
Characteristic impedance 50 ohm or 75 ohm (This model has 75 ohm)
High directivity
Good matching characteristics
Sturdy construction
Connectors: N female
Test port connector: N femal or N male (This model has N (f))
Dimension without connector (WxHxD): 72 x 57 x 20 mm
Connector Length: female 17 mm, male 19 mm
Weight: 240 g
€ 1,240 (net) $1,562 (US)